Friday, August 31, 2012

Calmark Cover, Part 3

Today we found new success in installing the Calmark cover on the Escape 19 and Great Husband summed it up, “Super-duper! It was a cinch!”  We are no longer fighting gravity to get the cover up onto the roof, and the whole operation took only a half hour, including installing the padding.


New method for removing the cover:

Unfasten the two black cords and pull them from under the belly of the camper to the non-door side of the camper. 

Near the buckle on each cord, bundle up all the excess cord length with bungees or wire ties. Fortunately, we never cut off all the excess length of these cords, and that extra weight was helpful later. 

Roll the front and back ends of the cover to the center of the camper, between the air conditioner and the Maxx fan. We do this with me helping on the ground and Great Husband moving a ladder around.

Secure the rolled-up cover by wrapping it with two bungees, one at each edge of the roof. The rolled-up cover doesn’t have to look especially tidy.  But the bungees keep the cover under control while it is stored so you can easily recognize the proper orientation when you are ready to put the cover back up.

From the door side of the camper, tug the rolled-up cover straight down into a large, clean trash can. The black cords should end up on top of the cover. The cover will remain stored in the trash can until you are ready to reinstall it on the camper.


New method for putting the cover back on:

Set up the trash can at the side of the camper.

The weight of the bundled-up black cords now becomes essential, because you can easily toss each of the black cords over the center top of the camper to the other side. Toss them over.

From the non-door side, pull the black cords toward that side while another person on the door side helps feed up the cover fabric out of the trash can. This is remarkably easy.

When the bungee cords are positioned at the edges of the roof, you know your cover is balanced from side to side.

Remove the bungee cords, and gradually unroll the cover toward the front and the back. Some of this can be done from the ground but some must be done by moving a ladder around.

Calmark cover stored in a trash can

Toss each black cord over the roof to the opposite side of the camper.

With me pulling the black cords from the non-door side,
Great Husband assists the cover fabric over the awning.
You can see the bungee around the fabric below his hand.

Here is the rolled-up and still-bungeed cover
on the non-door side.

We've taken off the bungees and started to unroll toward the front and back ends.

Assisting the fabric over the Maxx fan

And assisting the fabric over the pool noodles around the air conditioner


A bit more fabric-lifting to get it gently over the air conditioner

It's on! And nobody's cranky!

Tuesday, August 21, 2012

Escape Tips after Five Months

Always learning. We've had the Escape 19 for about five months now.

Pollyanna was wrong about needing only one BAL X-Chock. Our campsite at Sylvan Lake had some slope and it dropped off significantly immediately behind the camper. So we had leveling boards on one side, plus were using both X-Chocks for the first time. When getting ready to leave, Great Husband raised the stabilizing jacks and one tire slipped off a leveling board, which I had poorly positioned during set-up. The dual X-Chocks limited the camper movement to a significant jolt. I was inside the camper at the time, and pleased to avoid rolling down the hill.  http://norcoind.com/bal/products/consumer/chocks/chocks.shtml

The retractable screen door had been getting less retractable, tending to bunch up instead. Great Husband gave it a quick shot of silicone spray and that bit of lubricant made it operate like new again. 

Temperature sensor sits inside fridge
Some years ago Great Husband won a door prize at a car show--an indoor-outdoor thermometer intended for reading the outdoor temperature from inside your car. Instead, we mounted the indoor part on the surface of our refrigerator, and the outdoor part (the temperature sensor) inside the refrigerator. With this set-up, we can monitor the refrigerator temperature without opening the door. 

Digital read-out mounted on fridge door












We are glad to have two methods of emptying our tanks, and have been using the stinky slinky for quick dumps, followed later by thorough tank cleaning using the Sewer Solution, which macerates the tank contents without using any electricity. We especially like the back-fill feature of the Sewer Solution, since we can refill the tank with clean water and empty it repeatedly until we're convinced the tank is really clean. Too many dump stations do not have a threaded hose connection as is necessary for the Sewer Solution, but we make sure to find the right hose connection as the last stop before coming home. It's very obvious that the stinky slinky does only a basic job of draining the tanks, and plenty of "black" is left in the black water tank if the stinky slinky is your only method.  http://www.sewersolution.com/

Still loving the Escape 19. It is funny that when I show others the inside, I am most excited to show the bathroom, however small, however humble. 

Great Husband bought a great wax-substitute called RejeX. With it, the dead bugs wash off the front of the trailer so easily! In hindsight, it would have been nice to bring RejeX with us to the Escape factory, and apply some to the front of the Escape before we ever drove away.  http://www.rejex.com/

After more practice, the awning is now a breeze for us to open and close. I bet if we timed ourselves, we'd find it is up or down in 60 seconds. 


We purchased a 7-pack of awning hangers (Camco 42693), meant for hanging party lights from an awning. When the weather is right, we can hang our towels out to dry on the S-hooks included.  

Microfiber towels hang out to dry




Monday, August 20, 2012

Black Hills, South Dakota


Last week we Escaped to the Black Hills, a place we love for its wildlife and natural beauty, meanwhile avoiding the too-touristy towns, the casinos, and the Sturgis motorcycle rally. We have been to the Black Hills four previous times, when camping meant a pop-up full of kids, but we always find something new to discover and favorite activities worth repeating.

Mammoth Site
Mammoth Site, Hot Springs, SD – Here you can see the bones of 60 mammoths right in the dig site where they continue to be uncovered and studied. Great place to visit.
1880s Train





1880s train ride starting in Hill City – What a pleasant two-hour ride to Keystone and back! We sat in an open-air car and enjoyed the view and friendly, low-key narration. 







Mount Rushmore – We always enjoy seeing the four Presidents carved on the mountain. This time we didn't even take pictures.

Relaxing in the family room with "The Scarlet Pimpernel" on the laptop.
Sylvan Lake
Sylvan Lake – Two Ukrainian sisters were working the boat rental, and we took a canoe out on Sylvan Lake for an hour. Near the dock end of the lake, a wedding was underway and we listened in a bit without being intrusive. As I climbed out of the canoe, I was thankful to not fall into the lake in front of the wedding guests.

Black Hills Playhouse – This theater is a gem, presenting several plays each summer. We saw “The Three Musketeers”, an oddly humorous story with elaborate and well-choreographed sword fights.

The Civilian Conservation Corps built this fire watchtower at Harney Peak.
Hike to Harney Peak – This hike is rated moderate, but because of its length (over 7 miles round trip), it was plenty challenging. I could not, however, give up part way, since along the way we met an older man with heart trouble, diabetes, and other ailments, and even he was very steadily going after that mountain. By the way, if our conversations with strangers on the hike are any indication about the upcoming presidential election, Obama is in trouble.

View from Harney Peak
Up close and personal
Wildlife Loop Drive – Even if you didn’t encounter any critters, this would be a stunning drive. But we did encounter critters, including close encounters with bison herds (aka American buffalo), lots of pronghorn, lots of deer, prairie dogs, and one coyote. We recommend going off on one of the back gravel roads rather than staying on the primary wildlife loop.





We're told they are not feeling threatened unless they raise their tails.

Stay in your cars, humans!

And planned for next year – back to Custer State Park for the annual Buffalo Roundup! This takes place the last Monday in September each year. The bison are rounded up by volunteer cowboys and put into corrals, where they can be checked, branded and vaccinated. A month later a large number are sold at auction, and this helps support the park financially. It also reduces the winter bison population to a level that can be sustained by the available grassland. By spring the bison population booms again with the birth of the new calves!